SATO CL412E service manual DSW3

Section 2. Configuration

Dip Switch Settings

Firmware Download(DSW2-6):Places the printer in the Firmware Download mode for downloading new firmware into flash ROM.

DSW2-6	SETTING
Off	Disabled
On	Enabled

DSW2

ON

OFF

1 2 3 4 5 6 7 8

Protocol Code Selection (DSW2-7):Selects the command code set used.

DSW2

DSW2-7	SETTING	ON
Off	Standard	OFF
On	Non-Std.

1 2 3 4 5 6 7 8

M8400 Emulation Mode(DSW2-8):For emulating earlier series software commands. Should be used only if problems are encountered when using existing software. This switch will also affect the setttings selected by DSW1-7 and DSW1-8.

DSW2-8	SETTING
Off	Disabled
On	Enabled

DSW2

ON

OFF

1 2 3 4 5 6 7 8

Mode Selection(DSW3-1 and DSW3-2):Selects the operating mode of the printer. Batch/Continuous disables the label taken (dispense option) sensor.

						DSW3
DSW3-1	DSW3-2	SETTING	ON
Off	Off	Batch/Continuous
			OFF
Off	On	Tear Off
			1	2	3	4	5	6	7	8
On	Off	Cutter
On	On	Dispenser

Page 2-4 SATO CL408e/CL412e Service Manual

PN 9001078 Rev. B