Section 2. Configuration
LCD Panel — Card Mode
Memory->Card Copy Program Y/N
Memory->cardCopy
program y/n
This selection allows the user to copy the current firmware installed in the printer to a PCMCIA Memory Card.
STEP | PROCEDURE |
1.Use the LINE key to step the underlined cursor to the desired setting. IF Yes is selected, the printer will enter the Card Copy mode.
If No is selected, the display will advance to the mode display.
2.Confirm your selection by stepping the underline cursor to the Yes selection. If you select No, the display will return to the previous
selection.
copy start
yes no
3.Press the FEED key to accept the selection. If Yes was selected, the copy process will start.
memory-> card copy copying
4.Once the copy process is completed, press the FEED key to advance the display.
memory-> card copy completed
5.If an error is encountered in the copy process, one of the following messages will be displayed on the second line.
| CARD COPY/FORMAT |
|
| XXXXXXX ERROR |
|
|
|
|
R/W Error Indicates a Read/Write error occurred | ||
No Card Error | Indicates no card was recognized | |
Mem Full Error | Indicates that there is insufficient | |
| memory available | |
PN 9001078 | SATO CL408e/CL412e Service Manual | Page |
Rev. B |
|
|
