Section 2. Configuration
LCD Panel — Card Mode
Card->Memory Copy Program Y/N
card ->memoryCopy
program y/n
This selection allows you to copy printer firmware from the PCMCIA Memory card to the printer.
STEP | PROCEDURE |
1.Use the LINE key to step the underlined cursor to the desired setting. IF Yes is selected, the printer will enter the Card Copy mode.
If No is selected, the display will advance to the mode display.
2.Confirm your selection by stepping the underline cursor to the Yes selection. If you select No, the display will return to the previous
selection.
copy start
yes no
3.Press the FEED key to accept the selection. If Yes was selected, the copy process will start.
card-> memory copy copying
4.Once the copy process is completed, press the FEED key to advance the display.
card-> memory copy completed
5.If an error is encountered in the copy process, one of the following messages will be displayed on the second line.
| CARD COPY/FORMAT |
|
| XXXXXXX ERROR |
|
|
|
|
R/W Error Indicates a Read/Write error occurred | ||
No Card Error | Indicates no card was recognized | |
Mem Full Error | Indicates that there is insufficient | |
| memory available | |
Page | SATO CL408e/CL412e Service Manual |
