SATO CL412E service manual Ignore can/dle Yes no, Ribbon near end Enable disable, Service Mode

Section 2. Configuration

LCD Panel — Service Mode

Priority Setting LCD Command

priority setting lcd command

This selection allows the user to assign a priority for Print Darkness, Print Speed and Print Offset.

STEP PROCEDURE

1.Use the LINE key to step to the desired priority. If LCD is selected, the setting established via the LCD display/menu system will be used for an incoming label job, regardless of any different command settings. If Command is selected, any commands in the label job will take precedence and be used for printing the job and the LCD Display will reflect the new setting.

2.Once the desired setting is selected, press the FEED key to accept the setting and advance to the next display.

ignore can/dle

yes no

This function allows the user to disable:

<DLE> (Hex 10) the print stop command and

<CAN> (Hex 18) the cancel command.

Used for compatibility with some third party hardware and software. It is only displayed and functional when RS-232C HS serial interface is installed and configured for Status 4 Bi-direction operation.

ribbon near end

enable disable

This function is only displayed when a RS232 HS serial interface card is installed and configured for Status 3 Bi-direction operation. The disable function was added for compatibility with older non "e" version printers, where ribbon near end was not reported. Use the LINE key to select Enable or Disable and press FEED to save and exit.

Service Mode

service mode

To exit the Service Mode power the printer off, then back on.

PN 9001078	SATO CL408e/CL412e Service Manual	Page 2-31
Rev. B