SATO CL412E service manual All clear mode, All clear Counter eeprom, Counter all clear Yes no

Section 2. Configuration

LCD Panel — Maintenance Mode

All Clear Mode

This function is used to clear counters and reset the firmware and doesn't produce a test label.

STEP PROCEDURE

1.Record all current dip switch positions, then place all switches in the OFF position.

2.Place the DSW2-4 in the ON or up position.

3.Press the LINE and FEED key while simultaneously turning ON the power switch. When the printer beeps, release the keys. The following screens will appear.

initializing	maintenance mode
rom v00.00.00.00	dipsw2-4 on->off

4.Place the DSW-4 in the OFF position and the following screen will appear.

factory mode

5.Press the LINE key to display the next screen.

all clear mode

6.Press the FEED key to display the next screen.

all clear

counter eeprom

7.Press the LINE key to select either COUNTER or EEPROM. Select Counter to clear all counters.

Select EEPROM to clear/reset the firmware to factory default setting

8.Press the FEED key to display the next screen.

counter all clear

yes no

9.Press the LINE key to select YES or NO. If YES is selected press the FEED key to clear your selection.

counter all clear	all clear mode
completed

10.The printer will beep three times signaling the competion of the process.

11.Power off the printer to exit Maintenance Mode.

Page 2-36	SATO CL408e/CL412e Service Manual	PN 9001078
		Rev. B