SATO CL412E service manual External Signal Interface

Section 2. Configuration

Dip Switch Settings

Label Sensor Selection (DSW3-3):Enables or disables the Label Pitch sensor. If the sensor is enabled, it will detect the edge of the label and position it automatically. If it is disabled, the positioning must be under software control using Line Feed commands.

DSW3-3	SETTING
Off	Sensor Used
On	Sensor Not
	Used

DSW3

ON

OFF

1 2 3 4 5 6 7 8

Back-Feed Selection (DSW3-4):When Back-Feed is enabled, the printer will position the label for dispensing/cutting and retract it before printing the next label. The amount of backfeed is adjustable.

DSW3-4	SETTING
Off	Enabled
On	Disabled

DSW3

ON

OFF

1 2 3 4 5 6 7 8

External Signal Interface

The EXT connector on the printer rear panel is intended for use with the external printer accessories such as label rewinders or applicators. The 14-pin Centronics type connector provides a choice of four different output signals along with various error conditions.

EXT Print Start Signal Selection (DSW3-5): Allows an external device to initiate

a label print for synchronization with the applicator. See Section 3: Interface Specifications for a description of the signal level and requirements. When DSW3- 5 is On, the unit is in the Continuous print mode, Backfeed is disabled an External Signals are ignored.

DSW3-5	SETTING
Off	Disabled
On	Enabled

DSW3

ON

OFF

1 2 3 4 5 6 7 8

PN 9001078	SATO CL408e/CL412e Service Manual	Page 2-5
Rev. B