Section 2. Configuration
LCD Panel — Test Print Mode
Test Print Size | test print Size | |
10 CM | ||
10 cm | ||
| ||
|
|
NOTE: This display does not appear when a Memory Test Print is chosen. Only a small Memory Test Print can be printed.
Once you have selected the type of test label to be printed, use the FEED key to accept the selection and the display advances to the Test Print Size display. This display allows you to select the label width.
STEP | PROCEDURE |
1.Use the LINE key to select the label width. Each time the LINE key is pressed, the label size advances 1 cm until it reaches a maximum width of 10 cm at which point it will wrap to the smallest size of 4 cm.
2.Press the LINE key to accept the selection.
3.Press the FEED key to start printing test labels continuously.
4.Press the FEED key to stop the printer.
press feed key to stop printing
To exit the Test Print Mode, power the printer off, then back on.
Default Setting Mode
Occassionally it is desirable to reset all printer configuration settings to their original default conditions. This allows the operator to start the reconfiguration of the printer starting from a known set of conditions.
Default Setting Mode
default setting
yes no
To enter the Default Setting Mode press the FEED key while simultaneously powering on the printer. When the printer emits one long beep release the FEED and LINE keys.
STEP | PROCEDURE |
1.Use the LINE key to select either YES or NO.
2.Once the desired setting is selected, press the FEED key to accept the selection and the printer will reset to the original default conditions.
3.When the printer has completed the reset process, the Default Setting Completed display will appear. The printer is now in the default configuration.
default setting completed
To exit the Default Setting Mode, power the printer off, then back on.
Page | SATO CL408e/CL412e Service Manual |
PN 9001078 Rev. A
