Section 9. Optional Accessories
PCMCIA Memory Expansion Installation
Removing the Main PCB Board
NOTE: Many of the components on this board are susceptible to damage by static electricity. To avoid damage from static electricity, do not unpack new circuit boards from
STEP | PROCEDURE |
4.If an interface card is installed remove (2) screws holding the card to the rear cover and pull away to detach the card from the PCB Board.
Figs.
5.Remove (2) screws holding EXT Connector to cabinet. Figs.
6.Note cable connection locations, then disconnect all cables from the PCB Board. Fig.
7.Remove (3) screws holding the PCB Board to the frame. Fig.
Remove the board from the printer and set aside for installing the Memory PCB Board. Continue on Page
REMOVE (2) SCREWS AND PULL
AWAY TO DETACH IF INTERFACE
CARD IS INSTALLED
PCMCIA | REMOVE (2) SCREWS | Figs. |
| ||
HOLDING EXT CONNECTOR |
| |
MEMORY CARD |
| |
TO CABINET |
| |
COVER |
| |
|
|
Page | SATO CL408e/CL412e Service Manual |