SATO CL412E service manual RS232 Transmit/Receive Setting located on RS232 I/F Module

Section 2. Configuration

Dip Switch Settings

RS232 Transmit/Receive Setting (located on RS232 I/F Module)

Data Bit Selection (DSW1-1):This switch sets the printer to receive either 7 or 8

data bits for each byte transmitted.

DSW1

DSW1-1	SETTING	ON
Off	8 data bits	OFF
On	7 data bits
		1	2	3	4	5	6	7	8

Parity Selection (DSW1-2,DSW1-3):These switches select the type of parity used for error detection.

DSW1-2 DSW1-3		SETTING
Off	Off	None
Off	On	Even
On	Off	Odd
On	On	Not Used

DSW1

ON

OFF

1 2 3 4 5 6 7 8

Stop Bit Selection (DSW1-4):Selects the number of stop bits to end each byte transmission.

							DSW1
DSW1-4	SETTING		ON
Off	1	Stop Bit	OFF
On	2	Stop Bits
			1	2	3	4		5	6	7	8

Baud Rate Selection (DSW1-5, DSW1-6): port.

DSW1-5 DSW1-6		SETTING
Off	Off	9600
Off	On	19200
On	Off	38400
On	On	57600

Selects the data rate (bps) for the RS232

DSW1

ON

OFF

1 2 3 4 5 6 7 8

Protocol Selection (DSW1-7,DSW1-8):Selects the flow control and status reporting protocols.

(* Will select protocol Bi-Com 2 for M-8400 if DSW2-8 is ON)

DSW1-7 DSW1-8		SETTING
Off	Off	Rdy/Bsy
Off	On	Xon/Xoff
On	Off	Bi-Com 3
On	On	Bi-Com 4*

DSW1

ON

OFF

1 2 3 4 5 6 7 8

Page 2-2 SATO CL408e/CL412e Service Manual

PN 9001078 Rev. B