SATO CL412E service manual Offset Label Stop Position Adjustment, Offset-Vr

Section 4. Electric Checks and Adjustments

4.8 Offset Label Stop Position Adjustment

Used for fine adjustment of label stop position for Tear Off, Cutter and Dispense Modes. The Label Stop Position is adjusted with the Offset potentiometer on the Front Panel.

	Note: The stop position only is
	changed with the Offset-VR.
	The print position is changed with
OFFSET-VR	the Pitch-VR.
	The OFFSET-VR adjustment range
	is +/- 3.75mm.

STEP PROCEDURE

1.Open the Front Door for access to Offset-VR.

2.Turn Offset-VR to the center position.

3.Press the FEED key while simultaneously turning ON the power switch.

4.When the printer beeps, release the key. The following screens will appear.

initializing

rom v00.00.00.00

test print mode configuration

5.Press the FEED key to display the next screen.

test print size 10cm

6.Use the LINE Key to step to the second digit of the counter to the desired setting. The display will increment one step each time the LINE key is pressed. After the reading will advances to a setting of 09, it will automatically wrap and start at 10 CM again.

7.Press the FEED key for a test print. Press the FEED key again to stop printing.

press feed key to stop printing

8.Adjust stop the position using the Offset-VR and feed another label. When the adjustment is correct, turn the printer off. If the print position can't be adjusted replace the Display Panel PCB. Refer to Section 6.

Page 4-12 SATO CL408e/CL412e Service Manual

PN 9001078 Rev. B