Siemens appendix Replacing modules, Removing and replacing the Simotion D410

Maintenance and service 5

5.1Replacing modules

5.1.1Removing and replacing the SIMOTION D410

Overview

You must replace the entire SIMOTION D410 module.

WARNING

Always shut down the load power supply before you replace the SIMOTION D410 module. You shut down power using the On/Off switch of the PS power supply module, for example.

Note that power modules with FSB performance rating or higher still carry a residual intermediate voltage after shutdown. Wait 10 minutes before you remove any screws.

You can replace a SIMOTION D410 DP with a SIMOTION D410 PN module and vice versa. Replace the device in HW Config

Replacing a SIMOTION D410 DP with a SIMOTION D410 PN module and vice versa

Note

The following procedure describes how you replace a SIMOTION D410 DP with a SIMOTION D410 PN of the same firmware version (and vice versa). The procedure for performing a software and firmware upgrade is described in Section Performing a software and firmware update (Page 126).

Proceed as follows:

1.Double-click the SIMOTION D410 to be replaced in the Project Navigator of SIMOTION SCOUT. HW Config opens.

2.In the hardware catalog, open the appropriate folder structure: e.g. Drive Based\SIMOTION D410\6AU1 410-0AB0-0AA0

D410	121
Commissioning Manual, 08/2008 Edition