StorageTek 6 manual Load the TAPEREQ Parameters From YOUR.DSNMEMBER, Treqdef, unitname, host-id

TREQDEF

UNIT

specifies the unit where the definition data set is located.

unitname

specifies the unit name. If the definition data set is not cataloged and this parameter is omitted, a unit name of SYSALLDA is the default.

HOSTID

(This parameter is valid only for use in PARMLIB, so that multiple systems can share a PARMLIB member containing TAPEREQ, VOLATTR, or UNITATTR statements for different releases of HSC. If entered from the console, message SLS0018I is issued.)

Optionally, the HOSTid parameter limits the execution of this control statement to the specified hosts. If one of the specified hostids matches the host executing this control statement, the control statement is executed for that host. Otherwise, it is ignored. If this parameter is omitted, the control statement is executed on all hosts.

host-id

specifies the name of one or more hosts from which to execute this control statement. Multiple hosts must be separated by commas.

Examples

The following examples illustrate the use of the TREQDEF statement.

Load the TAPEREQ Parameters From YOUR.DSN(MEMBER)

TREQDEF DSN(‘YOUR.DSN(MEMBER)’)

Load the TAPEREQ Parameters From DASD Volume DISK01

TREQDEF DSN(YOUR.DSN1) VOLUME(DISK01)

Chapter 3. HSC Control Statements and HSC Start Procedure 135

1st ed., 6/30/04 - 312579601