StorageTek 6 manual ACS UTIL Exec

ACS UTIL Exec

The most convenient way for a beginner to run the utilities is to use the ACS UTIL exec. When provided with the names of the utilities to be executed, the ACS UTIL exec builds a file containing the control statements required to execute these utilities in the appropriate SCP or CMS environment. The file is then displayed for editing by the user who must then fill in, or change the supplied template parameters. The exec then checks these parameters for errors and submits the utility for execution.

The ACS UTIL exec may be used for any utilities that run in the SCP or CMS environments.

More than one utility may be invoked at a time.

The ACS UTIL command has the following syntax:

EXEC ACS UTIL util­list

This command creates utility statements to execute all the utilities named in util-list. The valid values that may be entered in the util-list are listed below and are also shown in the utility syntax examples provided throughout the remainder of this chapter. The minimum abbreviation is denoted by uppercase letters. Appendix A, “Macros, Control Statements, Utilities, and Commands Syntax Reference” on page 429 contains a complete syntax for all of the utilities.

ACTIVities	Activity distribution report
ACTIVity	Activity distribution report
AUDIT	Audit library contents
BACKup	Back up the library control data set
EJECt	Eject a list of volumes
ENTEr	Enter volumes through the CAP
HSCINIT	Create HSC startup job
IVP1	JCL for Installation Verification
LIBGen	Decompile the LIBGEN database
MOVe	Move volume(s) to other locations in the library
OFFLoad	Offload a journal data set
RECONfig	Reconfigure the library subsystem
REPLaceall	Replace the scratch volume list
RESTore	Restore control data set from a backup
SCRAtch	Change volumes to scratch status
SCREdist	Scratch volume redistribution

174VM/HSC 6.0 System Programmer’s Guide

1st ed., 6/30/04 - 312579601