StorageTek 6 manual =Nodebug, =Ddict, fieldname

=NODEBUG

This diagnostic command terminates the special ‘‘debug’’ mode. ‘CP SET RUN ON’ is also executed.

=

the command character for the DIAG subsystem. The default is ‘‘=’’, but may be set to any character by the SUBSYS command that started the subsystem.

=DDICT

This diagnostic command displays data dictionary information describing an SCP or HSC data area fieldname.

The information returned is the assembler definition of the field with the DSECT name and the offset from the DSECT.

‘CP SET RUN OFF’ is executed, and the SCP debug mode is entered. The diagnostic command ‘=NODEBUG’ terminates the debug mode.

=

the command character for the DIAG subsystem. The default is ‘‘=,’’ but may be set to any character by the SUBSYS command that started the subsystem.

fieldname

the name of a field in an SCP or HSC data structure.

Examples:

Issuing the command:

=DDICT LVTSSCVT

Results in:

LVT: LVTSSCVT+000C DS A

Issuing the command:

=DD ATPARM

Results in:

ATNAME: ATPARM +0018 DS (16)A

Issuing the command:

=DD CMDTOKS

Results in:

CMDTOKS: CMDPLIST+00CC DS (32)XL(4)

380VM/HSC 6.0 System Programmer’s Guide

1st ed., 6/30/04 - 312579601