StorageTek 6 manual Database Decompile Output Description, Device, Label

Database Decompile

Output Description

Outputs resulting from the execution of the Database Decompile utility include:

•a valid LIBGEN file matching the existing control data set. The output file has the following characteristics:

-All station and drive addresses are 4-character addresses.

-In cases where multiple parameters point to the same label statement, the utility duplicates the statement with a unique label and points each parameter to a different, although identical statement.

-Labels generated in the output LIBGEN are listed in Table 12.

-If an EJect password exists, it is not displayed. Instead, the following line is displayed: EJCTPAS=????????

Table 12. Label Descriptions for Devices in Output LIBGEN

Device	Label	Description
ACS	ACSaa	aa is the sequential hexadecimal ACSid value
		(00 through FF), beginning with zero.
LSM	LSMaall	aa is the ACSid, and ll is the sequential
		hexadecimal LSMid value (00 through 17),
		beginning with zero.
STATION	STaah	aa is the ACSid, and h is the sequential
		hexadecimal host index value (0 through F),
		beginning with zero.
PANEL	Paallpp	aa is the ACSid, ll is the LSMid, and pp is the
		sequential decimal panel number (0 through 10).
DRIVE	Daallpph	aa is the ACSid, ll is the LSMid, pp is the
		decimal panel number, and h is the hexadecimal
		host index value, beginning with zero.

•messages associated with error conditions resulting from an unsuccessful execution of the utility.

Refer to Figure 12 on page 229 for an example of output from the utility.

228VM/HSC 6.0 System Programmer’s Guide

1st ed., 6/30/04 - 312579601