Minimizing I/O Time

Reconfiguration

Minimizing I/O Time

Any or all of the following approaches will reduce reconfiguration time:

Using a solid state disk (SSD) device (such as StorageTek’s 4080)

Having no scratch tapes in the old CDS, rather than many scratch tapes

Note: Reconfiguration to real DASD with many scratch volumes has been known to take hours of wall clock time.

Minimize I/O to the CDS copies by defining only the new primary CDS copy to RECONFIG. Afterward, copy the new primary CDS copy to the new secondary and standby CDS copies as needed.

A way to minimize I/O time is to copy all CDSs to an SSD device before reconfiguration. To use the SSD, create a multiple-step reconfiguration procedure to:

1.Copy the old and new CDSs to the SSD data set. If shadowing is enabled, both the primary and the secondary must be copied to the SSD data set.

Warning: Do not include CDSDEF or RECDEF statements in the PARMLIB control statements. (If included, they override the statements for the SSD.)

2.Perform the reconfiguration using the SSD data sets as the old and new CDSs.

3.Copy the new SSD CDSs to the real, new CDSs on DASD. The old CDSs need not be copied since they have not been updated.

Running a Successful Reconfiguration

While the Reconfiguration utility is in process, the library is unavailable to the user.

Notes:

1.Deviations to the reconfiguration procedure may be required as determined by the system programmer familiar with the environment.

2.Unless otherwise stated, all operations are on MAINTSTK.

The steps necessary to achieve a successful reconfiguration are as follows:

1. Run the Database Decompile utility to create a new LIBGEN.

Caution: Do not rely on old LIBGENs for accuracy. If you do not perform this step, modifications made to the CDS (e.g., changes entered from the SET utility) will not be added to the LIBGEN. Thus, you may encounter a mismatch between your CDS and LIBGEN.

270VM/HSC 6.0 System Programmer’s Guide

1st ed., 6/30/04 - 312579601

Page 300
Image 300
StorageTek 6 manual Running a Successful Reconfiguration, Minimizing I/O Time, Notes