Load the VOLATTR Parameters From YOUR.DSN(MEMBER)

VOLDEF

UNIT

specifies the unit where the definition data set is located.

unitname

specifies the unit name. If the definition data set is not cataloged and this parameter is omitted, a unit name of SYSALLDA is the default.

HOSTID

(This parameter is valid only for use in PARMLIB, so that multiple systems can share a PARMLIB member containing TAPEREQ, VOLATTR, or UNITATTR statements for different releases of HSC. If entered from the console, message SLS0018I is issued.)

Optionally, limits the execution of this control statement to the specified hosts. If one of the specified hostids matches the host executing this control statement, the control statement is executed for that host. Otherwise, it is ignored. If this parameter is omitted, the control statement is executed on all hosts.

host-id

specifies the name of one or more hosts from which to execute this control statement. Multiple hosts must be separated by commas.

Examples

The following examples illustrate the use of the VOLDEF statement.

Load the VOLATTR Parameters From YOUR.DSN(MEMBER)

VOLDEF DSN(‘YOUR.DSN(MEMBER)’)

Load the VOLATTR Parameters From DASD Volume DISK02

VOLDEF DSN(YOUR.DSN2) VOLUME(DISK02)

156VM/HSC 6.0 System Programmer’s Guide

1st ed., 6/30/04 - 312579601

Page 186
Image 186
StorageTek 6 manual Load the VOLATTR Parameters From YOUR.DSNMEMBER, Voldef, unitname, host-id, Examples