StorageTek 6 LKEYDEF LKEYDEF Command and Control Statement, Command Name, Parameter Descriptions

LKEYDEF

LKEYDEF Command and Control Statement

The LKEYDEF command/control statement retrieves LKEYINFO control statements containing HSC license key information, and loads them into an address space where they are available for retrieval by the HSC license key validation service.

Refer to the VM/HSC Installation Guide for more information about StorageTek license keys.

Warning: The LKEYDEF control statement must be present in the HSC START procedure prior to initialization.

The LKEYDEF operator command can be issued from the console without terminating the HSC.

Syntax

LKEYDEF

DATASET(dataset.name) DSN(dataset.name)

VOLume(volser)

UNIT(unitname)HOSTID(host-id)

Command Name

LKEYDEF

initiates the LKEYDEF command or control statement.

Parameter Descriptions

DATASET or DSN

Specifies the name of the data set containing the LKEYINFO control statement(s).

dataset-name

Indicates the name of the data set.

The definition data set can be a fixed length 80-byte sequential data set, or a fixed length 80-byte member of a PDS. If the definition data set is a member of a PDS, you must enclose the PDS and member name within single quotes.

VOLume

Optionally, specifies the volume on which the data set resides. This parameter is required if the data set is not cataloged.

volser

Indicates the volume serial number.

94VM/HSC 6.0 System Programmer’s Guide

1st ed., 6/30/04 - 312579601