StorageTek 6 manual Reconfiguration, q.Issue the following command

Reconfiguration

statements and deleting the DSNs created in step 13d on page 260. Do not alter DBPRMNEW or DBSHDNEW.

Note: Virtual device addresses may need to be changed in ACS SYSPROF when adding new data set names.

o.Issue the following command to create a job to reconfigure the new library data sets:

EXEC ACS UTIL RECONFIG (NOSEND

/JOB	jobname	SLSBINIT
/PARM	E(E086)	F(23) MEMBER(XX) RECONFIG
/FILE	SLSSYSXX *

/*	DEFINE CONTROL DATA SETS */
CDSDEF	DSN1=<prm.dsname>, VOL1=<vol1>, UNIT1=<unit1>
	DSN2=<sec.dsname>, VOL2=<vol2>, UNIT2=<unit2> ­
	DSN3=<stb.dsname>, VOL3=<vol3>, UNIT3=<unit3>
/*	DEFINE RECONFIG DATA SETS #/
RECDEF	DSN1=<prmnew.dsname>, VOL1=<vol1>, UNIT1=<unit1> ­
	DSN2=<secnew.dsname>, VOL2=<vol2>, UNIT2=<unit2>

p.Verify that the information is correct and file the job. Modify the data set, volume, and unit information as necessary.

q.Issue the following command:

COPY ACS SYSPROF A ACS SYSPROF B (REPLACE

r. Issue the following commands to recycle the SCP on STKACS:

STOPSCP ACCESS 192 D EXEC ACS INIT (NOJOB

s. Issue the following command:

ERASE ACS SYSPROF A

t. Issue the following command to submit the RECONFIG job created earlier:

EXEC ACS SUBMIT RECONFIG SLKJCL

The reconfiguration job starts the HSC and copies status information from the old to the new control data set. Wait for the job to complete.

Note: If the Reconfig fails, look at the job log for an indication of the cause of the failure.

u. Issue the following command on the STKACS service machine to shut it down:

STOPSCP

14.Log off the STKACS service machine.

15.Have the CSE make any necessary hardware changes.

274VM/HSC 6.0 System Programmer’s Guide

1st ed., 6/30/04 - 312579601