StorageTek 6 manual Creating an SLKJCL File for Starting the HSC, PARM Statement, Syntax

Creating an SLKJCL File for Starting the HSC

An SLKJCL file must be created on the ACS191-disk. The ACS INIT command submits the SLKJCL file. This loads the nucleus of the HSC into main storage, instructs the SCP to allocate data sets, and invokes the library host software initialization routine.

Note: Refer to “EXECParm Control Statement” on page 90 for an alternative method of specifying GTF Eid and Fid parameters. Also, see ‘‘HSC Initialization Parameters’’ and ‘‘HSCPARM’’ in the HSC Installation Guide.

This section describes how to create the SLKJCL file. A typical syntax for the /PARM statement and full descriptions of each of the parameters follows.

/PARM Statement

Syntax
/PARM	BASE
	SSYS(subsystem)
	COLD
	RESET
	Eid(xxxx)
	Fid(xx)
	Member(xx)
	Dialog(	Off	)
		Both
		Console
		Log
	RECONFIG

/PARM Statement Parameters

/PARM

defines the list of parameters passed to the HSC initialization routine.

Note: If you enter more than one of the following parameters, you must separate them with a blank space (e.g., BASE SSYS(subsystem) RESET).

BASE

specifies that the HSC initialize and execute at the base service level.

Chapter 3. HSC Control Statements and HSC Start Procedure 157

1st ed., 6/30/04 - 312579601