StorageTek 6 manual cap-list, Eject Cartridge

Eject Cartridge

STK2PA

indicates a T9940A transport.

STK2PA34

indicates a 3490E-image T9940A transport.

STK2PA35

indicates a 3590-image T9940A transport.

STK2PB

indicates a T9940B transport.

STK2PB34

indicates a 3490E-image T9940B transport.

STK2PB35

indicates a 3590-image T9940B transport.

CAP

specifies which Cartridge Access Port(s) is being used for the operation.

This utility ejects scratch volumes to the specified CAP(s) only. EJECt searches for scratch volumes only in the LSMs that contain the specified CAP(s).

Note: If a CAP has not been specified, EJECt determines the CAP to use based upon the CAPPref command setting (refer to ‘‘CAP Preference (CAPPref) Command and Control Statement’’ in the HSC Operator’s Guide).

If a CAP preference has not been specified, the HSC displays a message and waits until the user enters a CAPPref value. Pass-thrus can be made to CAPs specified by CAPPref.

(cap-list)

cap-listidentifies the Cartridge Access Port(s). The cap-listrequires explicitly specified CAPids separated by commas. A CAPid range is not allowed.

If more than one CAPid is specified, the elements must be separated by blanks or commas, and the entire list must be enclosed in parentheses. If no CAP is specified, one is chosen in each ACS.

The format for cap-idis AA:LL:CC where AA is the ACS number (hexadecimal 00-FF), LL is the LSM number (hexadecimal 00-17), and

CCis the CAP number. Allowable values for CC are:

00

•For 4410 and 9310 LSMs, standard 21-cell CAP or the right-hand 40-cell enhanced CAP

Chapter 4. Utility Functions 245

1st ed., 6/30/04 - 312579601