StorageTek 6 manual Reconfiguration, Comment out any AUTOJOB statements

Reconfiguration

13.Perform the following tasks to prepare for reconfiguration: a. Issue the following commands:

ACCESS 191 A

ACCESS 254 B

ACCESS 255 C

The 191-disk is MAINTSTK 191, the 254-disk is the RUN-disk, and the 255-disk is STKACS 191.

b. Make a backup copy of the ACS SYSPROF by issuing:

COPY ACS SYSPROF B ACSOLD SYSPROF A (REPLACE

c.Copy ACS SYSPROF from the RUN-disk (B) to the A-disk. This allows you to modify ACS SYSPROF for the Reconfig and ensure it is correct before placing it back on the RUN-disk.

COPY ACS SYSPROF B ACS SYSPROF A

d.XEDIT ACS SYSPROF A to describe the new data sets and LIBGEN module. In particular, modify the following parameters:

LIBGEN	file name of the LIBGEN load module.
SLSCNTL	DSN of the new primary control data set (for SLICREAT).
	Comment out the old statement to use later (see step 13n on
	page 4-95).
SLSCNTL2	DSN of the new secondary control data set (for SLICREAT).
	Comment out the old statement to use later (see step 13n on
	page 4-95).
SLSSTBY	DSN of the new standby control data set (for SLICREAT).
SLSJRNxx	DSNs of any new journal data sets (for SLICREAT).
SLSOFFxx	DSNs of new journal off-load data sets.
SLSBKUP	DSN of new backup data set. STATION list of station
	addresses should be corrected.
DBPRMNEW	DSN of the new primary control data set (for RECONFIG).
	Copy the unit address and DSN from the new SLSCNTL
	statement. DBSHDNEW DSN of the new secondary control
	data set (for RECONFIG). Copy the unit address and DSN
	from the new SLSCNTL2 statement.

Comment out any AUTOJOB statements.

272VM/HSC 6.0 System Programmer’s Guide

1st ed., 6/30/04 - 312579601