StorageTek 6 Volume Report Utility Name, volser or vol-range or vol-list, Parameters, acs-id

Volume Report

Utility Name

VOLRpt

specifies that a volume report is to be produced.

Parameters

ACS

optionally specifies that a report is to be produced for only a particular ACS.

(acs-id)

The one or two digit hexadecimal ACS identifier.

LSM

optionally specifies that a report is to be produced for only certain LSMs within an ACS.

(lsm-list)

lsm-listindicates the LSMs. An lsm-list can be a single LSMid or a list of LSMids. An LSMid (lsm-id) is made up of the ACSid (hexadecimal 00-FF) and the LSM number (hexadecimal 00-17) separated by a colon (:).

An LSM range is not allowed. If a list is specified, the elements must be separated by blanks or commas, and the entire list enclosed in parentheses.

VOLser or VOLume

optionally specifies that the report only contain information on certain VOLSERs.

(volser or vol-range or vol-list)

volser, vol-range, and vol-listindicate the volume serial numbers requested. Any subranges of volumes specified in the vol-list that are not in the control data set are listed in the Control Card Image Listing portion of the report using one line per subrange.

A percent sign (‘‘%’’) may be used as a ‘‘wildcard’’ character in the VOLSER to specify pattern matching. The percent sign designates that any single character can match the corresponding position in the VOLSER.

For example, A9%%%% specifies that all of the six-character volume serial numbers that begin with the characters ‘‘A9’’ are selected for the report.

Q%12% specifies that all five-character VOLSERs that begin with ‘‘Q’’ and have a ‘‘12’’ in the third and fourth positions of the VOLSER are selected for the report. The percent sign cannot be specified in a range specification.

Therefore, ‘‘A%0000-A%9999’’ is invalid.

In the Volume Report Listing of the utility, the volumes requested which are not in the control data set are not listed.

328VM/HSC 6.0 System Programmer’s Guide

1st ed., 6/30/04 - 312579601