
Chapter 5 Admin Terminal Commands
ENABLE
Note:
Previously disabled confer- ences or DSP’s can also be re- enabled using this command. (See the “disable” command for details)
FHANG
HELP
The above command disables DSP 122 in the 1st example. and DSPs 14 through 43 in the 2nd example.
These DSP numbers are associated with logical DSP’s and NOT physical DSPs on the NMS board.
Syntax: disable conf <NMS board #>
Examples:
disable conf 7
The above command disables all conferences on board 7. This command would normally only be used by engineering to bypass conferences on failed NMS boards.
Enables the specified trunks that were disabled via the disable command.
Syntax: enable <trunk # or range of trunks>
Trunk numbers can be entered as single trunks numbers or a range of trunks by separating the trunks numbers with a dash
Examples:
enable 7
enable 7 9 14
enable
Simulates a Far End
Displays help information on the specified Admin_Terminal command. If no command is entered, a list of all Admin_Terminal commands is displayed.
Page | Version 4.0 | CPSEE_TSP500 User Guide |
| This document is confidential and proprietary to SER Solutions and is not for external use. |