Avaya CPSEE_TSP500 manual Cmd, Conf, Conns

Chapter 5 Admin Terminal Commands

Syntax:

clock [-s -u]

The “-s” switch displays the current clock status. If no switch is supplied, the “-s” switch is assumed.

The “-u” switch forces the TSP to check for updated clock status.

	Table 5-2: "clock s" Command
Option		Description
Board Number		Board Slot Location.
Clock Mode		Indicates if board is A Clock, B Clock, or Slave.
Primary Source		Indicates source of clock: NETWORK with span
		number, H100 A, H100 B, INTERNAL.
Clock Status		Displays status for A Clock and B Clock. Values:
		GOOD and BAD.

CMD

This command allowed CTI Protocol B messages to be entered at the

Admin_Terminal.

Note:

Intended for engineering use only.

CONF

Displays any conferences or monitoring sessions in progress.

Example:
Conf #001 B7S68 3 C S1	T1	T4
....

The above shows conference #1 including 3 parties (Station 1, Trunk 1, and

Trunk 24). The conference being used is on Board 7 – Stream 68 (B7S68),

CONNS

Displays the IP addresses of connected Adjuncts or Dumb Terminals.

Example:

CTI Connection fd = 4 = 199.199.199.199

Dumb Terminal fd = 3 = 199.199.199.200

Page 5-6	Version 4.0	CPSEE_TSP500 User Guide
	This document is confidential and proprietary to SER Solutions and is not for external use.