Avaya CPSEE_TSP500 manual Option Flags, #123# Key = Use #123# as the key = Use \*123\* as the key

Chapter 5 Admin Terminal Commands

		Table 5-6: Option Flags.
Option		Description
Allow Dial Tone	1	= Provide dial tone to stations.
To Stations	0	– Don’t provide dial tone to stations.
Allow Manual	1	= Allow Manual Dialing.
Dialing	0	= Inhibit Manual Dialing.
Process SITs	Specifies that extended call status provided in the ISDN PROGRESSING
via D Channel	message is used to classify the call.
	1=Analyze the call using extended call status information.
	0=Analyze the call using in-band SIT tone detection.
Perform Zapper	1 = Analyze for Zapper devices. – if a SIT is detected and answer supervision
Detection	is received, the SIT will be ignored and the call will continue to be analyzed for
	Live voice or Answering Machine.
	0 = Don’t analyze for Zappers. – If a SIT is detected regardless of supervision,
	it will be classified as the appropriate SIT.
Monitor Key-	This flag only applicable if the “install” flag MONITOR_KEY is turned ON (in
Use Pound Sign	the install flags). It allow choosing the asterisk or pound sign to be used in the
- #123#	key.
	1	= Use #123# as the key.
	0	= Use \*123\* as the key.
		Note:
	#123# is typically used when voice only monitors are used in a con-
	ference supplied by a telco conferencing service (i.e. AT&T Confer-
	encing Service) where the use of * will pull in operator assistance.
Allow Caller ID	Specifies that the Caller ID’s Name can be sent.
Name	1	= Allow sending Caller ID text.
	0	= Don’t send Caller ID Text.
	Note: This flag is used as a global prevention method. It should not be turned
	ON unless the carrier is willing to accept the Caller ID Text. Otherwise, dials
	may fail.
Ignore Cadence	1	= Ignore cadence breaks during Voice Detection.
Break	0	= Consider a break in ring cadence to be an answered call.
	This flag is normally turned ON.
Support New	Specifies whether events used to comply with FTC regulations will be sent to
Legislation	the adjunct.
Events	1	= Send FTC events to the adjunct.
	0	= Don’t send FTC events.
Dont Route	For Engineering Testing Only!
Inbound
Always Beep	Specifies that an agent will be beeped prior to being connected to a call.
Agent on Con-	1	= Beep agent prior to connecting call.
nect	0	= Do not beep agent prior to connecting call.

CPSEE_TSP500 User GuideVersion 4.0Page 5-15

This document is confidential and proprietary to SER Solutions and is not for external use.