Avaya CPSEE_TSP500 manual Span, Slots Command

Chapter 5 Admin Terminal Commands

	Table 5-24: SLOTS Command
Command		Description
Sl		Slot (Span) Number. An "*" indicates this span is
		the Clock Master.
Type		T = Trunk D = Digital Station.
		For ISDN lines another ‘D” next to the ‘T’ or ’D’
		indicates the D channel is down.
		Example:
		T Trunk (if ISDN, D-Channel is UP)
		D Digital Station (if ISDN, D-Channel is UP)
		TD Trunk – D-Channel is DOWN.
		DD Digital Station – D-Channel is DOWN
Protocol		Network protocol loaded into the firmware.
Trunks		Trunk Numbers associated with this span.
Alarm		Displays current Alarms R = RED, Y = YELLOW, B
		= BLUE, L = Loss of Signal.
RD		Historic count of RED alarms.
BL		Historic count of BLUE alarms.
YL		Historic count of YELLOW alarms.
SL		Count of slips.
TO		Count of timeouts that occurred on this span.
EC		Count of times error detection threshold was
		exceeded.
NA		Not applicable at this time.
BPV		Count of Bipolar Violations.
LSY		Count of Loss of Synchronization.
FE		Count of Framing Errors.
LOS		Count of Loss of Signal indications.

At the end for each line may appear a R_LOOP or L_LOOP if the span is in some form of loopback mode.

SPAN

This command is used to control the state of ISDN channels. Currently unavailable because features of this command are not fully supported by the TSP’s board venter (NMS).

CPSEE_TSP500 User GuideVersion 4.0Page 5-37

This document is confidential and proprietary to SER Solutions and is not for external use.