Chapter 5 Admin Terminal Commands
CRATE
Note:
Intended for engineering use only.
DIAL
Note:
Intended for engineering use only.
Sets the simulated connect rate. Only affects the Simulated TSP.
Performs an unclassified dial by dialing the number given. If a trunk number is supplied, the trunk must have been previously disabled using the disable command.
Syntax: dial <telephone number> [trunk number]
When the dial is launched it is connected to the music on hold port. If music on hold is configured on the TSP, the answering party will hear it. Otherwise the answering party will hear silence.
DISABLE
Disables the specified trunks. It can also be used to disable DSP’s or Confer- encing on speccific NMS boards.
Note:
Intended for engineering use only.
Syntax: disable <trunk # or range of trunks>
Trunk numbers can be entered as single trunks numbers or a range of trunks by separating the trunks numbers with a dash
Disabling trunks will prevent their use for dialing. The disable condition will exist until they are enabled via the “enable” command, or the TSP is restarted.
Examples:
disable 7
disable 7 9 14 19-24 disable 1-24 73-96
As stated above, this command disables trunks from being used for outbound dialing. It does not physically disable any hardware or line protocol. If an Inbound call arrives on a disabled trunk, it will be handled normally.
DSP’s and Conferences can be disabled by the following syntax:
Syntax: disable dsp <dsp# or range of dsp’s>
Examples:
disable dsp 122 disable dsp 14-43
CPSEE_TSP500 User Guide | Version 4.0 | Page |
This document is confidential and proprietary to SER Solutions and is not for external use. |
| |
