Cisco Systems ONS 15600 SDH manual DLP-F388 Remove an SFP/XFP, 18-101

Chapter 18 DLPs F300 to F399

DLP- F388 Remove an SFP/XFP

Step 2 If you are installing an SFP, orient the SFP so that the Cisco serial number label is facing away from the shelf (to the right). If you are installing an XFP, orient the XFP to the left.

Step 3 Unlatch the bail clasp before inserting it into the slot.

Step 4 Slide the SFP or XFP into the slot on the 1PIO or 4PIO (as appropriate) and move the bail clasp to secure the SFP or XFP.

Caution Do not remove the protective caps until you are ready to attach the network fiber-optic cable.

Note Multirate SFPs must be provisioned in CTC; single-rate PPMs do not need to be provisioned. As needed, complete the “DLP-F358 Provision a Multirate PPM” task on page 18-70.

Step 5 Return to your originating procedure (NTP).

DLP-F388 Remove an SFP/XFP

	Purpose	This task removes an XFP from a 1PIO module and removes an SFP from
		a 4PIO module on the ASAP card.
	Tools/Equipment	None
	Prerequisite Procedures	DLP-F384 Install the ASAP 1PIO and 4PIO (PIM) Modules, page 18-95
	Required/As Needed	As needed
	Onsite/Remote	Onsite or remote
	Security Level	Provisioning or higher
Step 1	Disconnect the network fiber cable from the SFP/XFP.
Step 2	Release the SFP/XFP from the 1PIO or 4PIO slot by unlatching the bail clasp and swinging it to the left.
Step 3	Slide the SFP/XFP out of the slot.
Step 4	As needed, complete the “DLP-F360 Delete a PPM” task on page 18-72to delete an SFP/XFP (PPM)
	from CTC.
Step 5	Return to your originating procedure (NTP).

	Cisco ONS 15600 SDH Procedure Guide, R8.0
October 2007		18-101