Cisco Systems ONS 15600 SDH manual Sf Ber, Sd Ber, 18-108

Chapter 18 DLPs F300 to F399

DLP- F392 Change Line Transmission Settings for STM-N Cards

Step 1 On the shelf graphic, double-click the STM-N card that you want to provision. The card view appears.

Step 2 For STM-16 or STM-64 cards, click the Provisioning > Line tabs. For the ASAP card, click the Provisioning > Optical > Line tabs.

Step 3 As needed, provision the options in Table 18-6for each STM-N port. (Some options might not be available on every card.)

Table 18-6	STM-N Card Line Settings
Heading		Description	Options
Port		Identifies the port number.	•	For an STM-16 card: 1–16
			• For an STM-64 card: 1–4
			• For an ASAP card: Up to 16 ports,
				denoted by either a 4PIO (PIM) or 1PIO,
				followed by port number or (PIM).
				(Example: 1-3-1 denotes the third port
				on 4PIO [PIM] Module 1. For a 1PIO,
				3-1-1 denotes the port on 1PIO [PIM]
				Module 3)
Port Name		Provides the ability to assign the	User-defined; name can be up to 32
		specified port a name.	alphanumeric/special characters (blank by
			default)
SF BER		Sets the signal fail bit error rate.	•	1E-3
			•	1E-4 (default)
			•	1E-5
SD BER		Sets the signal degrade bit error rate.	•	1E-5
			•	1E-6
			•	1E-7 (default)
			•	1E-8
			•	1E-9
Provides Sync		(Display only) Indicates that the port	•	Yes (checked)
		has been provisioned as a network	•	No (unchecked)
		element (NE) timing reference on
		another node.
Send Do Not		When checked, sends a do not use	•	Yes (checked)
Use		(DUS) message on the S1 byte	•	No (unchecked; default)
MS-SPRing		Chosen extended byte carries	•	K3
Ext. Byte		information that governs multiplex	•	Z2
		section shared protection ring
			•	E2
		(MS-SPRing) protection switches.
			•	F1

	Cisco ONS 15600 SDH Procedure Guide, R8.0
18-108	October 2007