Chapter 18 DLPs F300 to F399
DLP- F363 Add a Static TID-to-NSAP Entry to the TARP Data Cache
•LDB Flush—Sets the frequency period for flushing the LDB. The default is 5 minutes. The range is 0 to 1440 minutes.
•T1—Sets the amount of time to wait for a response to a Type 1 PDU. Type 1 PDUs seek a specific NE TID within an OSI Level 1 area. The default is 15 seconds. The range is 0 to 3600 seconds.
•T2—Sets the amount of time to wait for a response to a Type 2 PDU. TARP Type 2 PDUs seek a specific NE TID value within OSI Level 1 and Level 2 areas. The default is 25 seconds. The range is 0 to 3600 seconds.
•T3—Sets the amount of time to wait for an address resolution request. The default is 40 seconds. The range is 0 to 3600 seconds.
•T4—Sets the amount of time to wait for an error recovery. This timer begins after the T2 timer expires without finding the requested NE TID. The default is 20 seconds. The range is
0 to 3600 seconds.
Note Timers T1, T2, and T4 are not used if TARP PDUs Origination is not enabled.
Step 3 Click Apply.
Step 4 Return to your originating procedure (NTP).
DLP-F363 Add a Static TID-to-NSAP Entry to the TARP Data Cache
| Purpose | This task adds a static TID-to-NSAP entry to the TDC. The static entries |
| | are required for NEs that do not support TARP and are similar to static |
| | routes. For a specific TID, you must force a specific NSAP. |
| Tools/Equipment | None |
| Prerequisite procedures | DLP-F181 Log into CTC, page 16-34 |
| Required/As needed | As needed |
| Onsite/Remote | Onsite or remote |
| Security Level | Provisioner or higher |
| |
Step 1 | In node view, click the Provisioning > OSI > TARP > Static TDC tabs. |
Step 2 | Click Add Static Entry. | |
Step 3 | In the Add Static Entry dialog box, enter the following: |
•TID—Enter the TID of the NE. (For ONS nodes, the TID is the Node Name parameter on the node view Provisioning > General tab.)
•NSAP—Enter the OSI NSAP address in the NSAP field or, if preferred, click Use Mask and enter the address in the Masked NSAP Entry dialog box.
Step 4 Click OK to close the Masked NSAP Entry dialog box, if used, and then click OK to close the Add Static Entry dialog box.
Step 5 Return to your originating procedure (NTP).
| Cisco ONS 15600 SDH Procedure Guide, R8.0 |
18-76 | October 2007 |
