Chapter 18 DLPs F300 to F399

DLP- F354 Roll Two Cross-Connects on One Optical Circuit Using Manual Routing

DLP-F354 Roll Two Cross-Connects on One Optical Circuit Using Manual Routing

 

Purpose

This task reroutes a network path of an optical circuit using manual

 

 

routing.

 

Tools/Equipment

None

 

Prerequisite Procedures

DLP-F181 Log into CTC, page 16-34

 

Required/As Needed

As needed

 

Onsite/Remote

Onsite or remote

 

Security Level

Provisioning and higher

 

 

Step 1

From the View menu, choose Go To Network View.

Step 2

Click the Circuits tab.

 

Step 3

Click the circuit that you want to roll to a new path. The circuit must have a DISCOVERED status for

 

you to start a roll.

 

Step 4

From the Tools menu, choose Circuits > Roll Circuit.

Step 5

In the Roll Attributes area, complete the following (Figure 18-17 on page 18-63):

a.From the Circuit Roll Mode drop-down list, choose Auto to create an automatic roll or Manual to create a manual roll.

b.From the Circuit Type drop-down list, choose Dual to indicate that you want to roll two connections on the chosen circuit.

Step 6 Click Next.

Step 7 In the Pivot/Fixed Point 1 window, click the square representing the fixed path of the first cross-connect to be rolled (Figure 18-13 on page 18-58).

This path is a fixed point in the cross-connect involved in the roll process. The path identifier appears in the text box below the graphic image. The path that is not selected contains the Roll From path. The Roll From path is deleted after the roll is completed.

Step 8 Click Next.

Step 9 Complete one of the following:

If multiple Roll From paths exist, the Select Roll From dialog box appears. Select the path from which you want to roll traffic and click OK, then click Next (Figure 18-18 on page 18-64).

If multiple Roll From paths do not exist, click Next and continue with Step 10. The circuit status for the Roll From path changes from DISCOVERED to ROLL_PENDING.

Step 10 In the Pivot/Fixed Point 2 window, click the square that represents the fixed path of the second connection to be rolled.

The path that is not selected is the Roll From path. The Roll From path is deleted after the roll is complete. The path identifier appears in the text box below the graphic image.

Step 11 Click Next.

Step 12 In the Circuit Routing Preferences area, uncheck Route Automatically.

Step 13 Set the circuit path protection:

 

Cisco ONS 15600 SDH Procedure Guide, R8.0

18-66

October 2007

Page 66
Image 66
Cisco Systems ONS 15600 SDH manual Purpose, 18-66