Cisco Systems ONS 15600 SDH manual DLP-F384 Install the Asap 1PIO and 4PIO PIM Modules, 18-95

Chapter 18 DLPs F300 to F399

DLP- F384 Install the ASAP 1PIO and 4PIO (PIM) Modules

DLP-F384 Install the ASAP 1PIO and 4PIO (PIM) Modules

Purpose	This procedure explains how to install the 4-port I/O modules (4PIOs)
	and 1-port I/O modules (1PIOs), also known as Pluggable Interface
	Modules (PIMs), in the carrier modules of the ASAP card.
Tools/Equipment	4PIO modules and/or 1PIO modules
	#2 Phillips screwdriver
Prerequisite Procedures	DLP-F333 Install the ASAP Carrier Modules, page 18-33
Required/As Needed	As needed
Onsite/Remote	Onsite
Security Level	None

Warning During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly touch the midplane with your hand or any metal tool, or you could shock yourself. Statement 181

Caution Always use the supplied ESD wristband when working with a powered ONS 15600 SDH. Plug the wristband cable into the ESD jack located on the lower-left outside edge of the shelf.

Warning Class 1 laser product. Statement 1008

Warning Invisible laser radiation may be emitted from the end of the unterminated fiber cable or connector. Do not view directly with optical instruments. Viewing the laser output with certain optical instruments (for example, eye loupes, magnifiers, and microscopes) within a distance of 100 mm may pose an eye hazard. Statement 1056

Warning Use of controls, adjustments, or performing procedures other than those specified may result in hazardous radiation exposure. Statement 1057

Note For information about the ASAP card, refer to the Cisco ONS 15600 SDH Reference Manual.

Step 1 Remove the 1PIO or 4PIO module from the box and antistatic sleeve.

Step 2 Identify the slot on the ASAP card where you want to install the 1PIO or 4PIO module. Step 3 Carefully slide the module along the top and bottom guide rails into the correct slot.

Step 4 Tighten the screws at the top right and bottom left of the module. You can either hand-tighten the screws or remove the screw covers and use a Phillips screwdriver to tighten the screws.

Figure 18-22shows the 1PIO module faceplate.

	Cisco ONS 15600 SDH Procedure Guide, R8.0
October 2007		18-95