Cisco Systems ONS 15600 SDH manual DLP-F372 Edit the OSI Router Configuration, 18-83

Chapter 18 DLPs F300 to F399

DLP- F372 Edit the OSI Router Configuration

Note Changing a routing mode should be carefully considered. Additional information about OSI systems and protocols are provided in the “Management Network Connectivity” chapter of the Cisco ONS 15600 SDH Reference Manual.

Step 4 Although Cisco does not recommend changing the Link State Protocol Data Unit (LSP) buffer sizes, you can adjust the buffers in the following fields:

•L1 LSP Buffer Size—Adjusts the Level 1 link state PDU buffer size.

•L2 LSP Buffer Size—Adjusts the Level 2 link state PDU buffer size.

Step 5 Return to your originating procedure (NTP).

DLP-F372 Edit the OSI Router Configuration

Purpose	This task allows you to edit the OSI router configuration, including
	enabling and disabling OSI routers, editing the primary area address, and
	creating or editing additional area addresses.
Tools/Equipment	None
Prerequisite procedures	DLP-F181 Log into CTC, page 16-34
Required/As needed	As needed
Onsite/Remote	Onsite or remote
Security Level	Provisioning or higher

Step 1 Click the Provisioning > OSI > Routers > Setup tabs.

Step 2 Chose the router you want provision and click Edit.

Step 3 In the OSI Router Editor dialog box:

a.Check or uncheck the Enabled box to enable or disable the router.

Note Router 1 must be enabled before you can enable Routers 2 through 12.

b.For enabled routers, edit the primary area address, if needed. The address can be between 8 and 24 alphanumeric characters in length.

c.If you want to add or edit an area address to the primary area, enter the address at the bottom of the Multiple Area Addresses area. The area address can be 2 to 26 numeric characters (0–9) in length. Click Add.

d.Click OK.

Step 4 Return to your originating procedure (NTP).

	Cisco ONS 15600 SDH Procedure Guide, R8.0
October 2007		18-83