18-4
Cisco ONS 15600 SDH Procedure Guide, R8.0
October 2007
Chapter18 DLPs F300 to F399
DLP- F304 Repair an IP Tunnel
DLP-F304 Repair an IP Tunnel
Step1 Obtain the original IP address of the node in question.
Step2 From the View menu, choose Go to Network View.
Step3 From the Tools menu, choose Overhead Circuits > Repair IP Circuits.
Step4 Review the text in the IP Repair wizard and click Next.
Step5 In the Node IP address area, complete the following:
•Node—Choose the node that has a PARTIAL circuit.
•Old IP Address—Type the node’s original IP address.
Step6 Click Next.
Step7 Click Finish.
Step8 Return to your originating procedure (NTP).
DLP-F305 Provision Path Trace on Circuit Source and Destination Ports
Note This task assumes you are setting up path trace on a bidirectional circuit and setting up transmit strings
at the circuit source and destination.
Step1 From the View menu, choose Go to Network View.
Step2 Click the Circuits tab.
Step3 For the VC circuit you want to monitor, verify that the source and destination ports are on a card that can
transmit and receive the path trace string. Table18-1 provides a list of cards that support path trace.
Purpose This task repairs circuits that are in the PARTIAL status as a result of node
IP address changes.
Tools/Equipment None
Prerequisite Procedures See Chapter 6, “Create Circuits.” for circuit creation procedures.
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This task creates a path trace on VC circuit source ports and destination.
Tools/Equipment ONS15600 SDH cards capable of transmitting and receiving path trace
must be installed at the circuit source and destination ports. See Table18-1
for a list of cards.
Prerequisite Procedures DLP-F181 Log into CTC, page 16-34
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher