Chapter 18 DLPs F300 to F399

DLP- F339 Create a Two-Fiber MS-SPRing Manually

On the network view graphic, a green span line appears between all MS-SPRing nodes.

All E-W-MISMATCH, RING-MISMATCH, APSCIMP, APSCDFLTK, and MSSP-OOSYNC alarms are cleared. See the Cisco ONS 15600 SDH Troubleshooting Guide for alarm troubleshooting procedures.

Note The numbers in parentheses after the node name are the MS-SPRing node IDs assigned by CTC. Every ONS 15600 SDH in an MS-SPRing is given a unique node ID, 0 through 31. To change it, complete the “DLP-F340 Change an MS-SPRing Node ID” task on page 18-41.

Step 9 Return to your originating procedure (NTP).

DLP-F339 Create a Two-Fiber MS-SPRing Manually

 

Purpose

This tasks creates a two-fiber MS-SPRing at each MS-SPRing-provisioned

 

 

node without using the MS-SPRing wizard.

 

Tools/Equipment

None

 

Prerequisite Procedures

NTP-F147 Provision MS-SPRing Nodes, page 5-6

 

 

DLP-F181 Log into CTC, page 16-34

 

Required/As Needed

Required

 

Onsite/Remote

Onsite or remote

 

Security Level

Provisioning or higher

 

 

Step 1

In node view, click the Provisioning > MS-SPRingtabs.

Step 2

Click Create.

 

Step 3

In the Suggestion dialog box, click OK.

Step 4

In the Create MS-SPRing dialog box, set the MS-SPRing properties:

Ring Type—Choose two-fiber.

Ring Name—Assign a ring name. You must use the same ring name for each node in the MS-SPRing. Any alphanumeric character string is permissible, and uppercase and lowercase letters can be combined. Do not use the character string All in either uppercase or lowercase letters; this is a TL1 keyword and will be rejected. Do not choose a name that is already assigned to another MS-SPRing.

Node ID—Choose a Node ID from the drop-down list (0 through 31). The Node ID identifies the node to the MS-SPRing. Nodes in the same MS-SPRing must have unique Node IDs.

Reversion time—Set the amount of time that will pass before the traffic reverts to the original working path. The default is 5 minutes. All nodes in a MS-SPRing must have the same reversion time setting.

West Line—Assign the west MS-SPRing port for the node from the drop-down list.

Note The east and west ports must match the fiber connections and DCC terminations set up in the “NTP-F147 Provision MS-SPRing Nodes” procedure on page 5-6.

 

Cisco ONS 15600 SDH Procedure Guide, R8.0

18-40

October 2007

Page 40
Image 40
Cisco Systems ONS 15600 SDH manual DLP-F339 Create a Two-Fiber MS-SPRing Manually, 18-40