Cisco Systems ONS 15600 SDH manual 18-61

Chapter 18 DLPs F300 to F399

DLP- F352 Roll One Cross-Connect from an Optical Circuit to a Second Optical Circuit

Figure 18-16 Selecting Roll Attributes for a Single Roll onto a Second Circuit

Step 6 Click Next.

Step 7 In the Pivot/Fixed Point 1 window, click the square representing the facility that you want to keep (Figure 18-13 on page 18-58).

This facility is the fixed location in the cross-connect involved in the roll process. The identifier appears in the text box below the graphic image. The facility that is not selected is the Roll From path. The Roll From path is deleted after the roll is completed.

Step 8 Click Next.

Step 9 In the Select New End Point area, choose the Slot, Port, and VC3 or VC4 from the drop-down lists to identify the Roll To facility on the connection being rolled.

Step 10 Click Finish.

The statuses of the Roll From and Roll To circuits change from DISCOVERED to ROLL_PENDING in the Circuits tab.

Step 11 Click the Rolls tab. For the pending roll, view the Roll Valid Signal status. When one of the following conditions are met, continue with Step 12.

•If the Roll Valid Signal status is true, a valid signal was found on the new port.

•If the Roll Valid Signal status is false, a valid signal was not found. Wait until the signal is found before continuing with the next step. If the signal is not found, refer to the “General Troubleshooting” chapter in the Cisco ONS 15600 SDH Troubleshooting Guide. To cancel the roll, see the “DLP-F357 Cancel a Roll” task on page 18-70.

•The roll is a one-way destination roll and the Roll Valid Signal is false. It is not possible to get a “true” Roll Valid Signal status for a one-way destination roll.

Note You cannot cancel an automatic roll after a valid signal is found.

•A roll can be forced onto the Roll To Circuit destination without a valid signal by using the Force Valid Signal button. If you choose Force Valid Signal, traffic on the circuit that is involved in the roll will be dropped once the roll is completed.

	Cisco ONS 15600 SDH Procedure Guide, R8.0
October 2007		18-61