Cisco Systems ONS 15600 SDH manual DLP-F346 Create an MS-SPRing on a Single Node, 18-49

Chapter 18 DLPs F300 to F399

DLP- F346 Create an MS-SPRing on a Single Node

Tip To move an icon to a new location, for example, to see MS-SPRing channel (port) information more clearly, click an icon on the Edit MS-SPRing network graphic and while pressing Ctrl, drag the icon to a new location.

Step 4 Right-click the MS-SPRing node channel (port) where the manual ring switch was applied and choose Set West Protection Operation or Set East Protection Operation, as applicable.

Step 5 In the dialog box, choose CLEAR from the drop-down list. Click OK.

Step 6 Click Yes in the Confirm MS-SPRing Operation dialog box. The letter “M” is removed from the channel (port) and the span turns green on the network view map.

Step 7 From the File menu, choose Close.

Step 8 Return to your originating procedure (NTP).

DLP-F346 Create an MS-SPRing on a Single Node

	Purpose	This task creates an MS-SPRing on a single node. Use this task to add a
		node to an existing MS-SPRing or to delete and then recreate an
		MS-SPRing temporarily on one node.
	Tools/Equipment	None
	Prerequisite Procedures	DLP-F181 Log into CTC, page 16-34
	Required/As Needed	As needed
	Onsite/Remote	Onsite
	Security Level	Provisioning or higher
Step 1	In node view, click the Provisioning > MS-SPRingtabs.
Step 2	In the Suggestion dialog box, click OK.
Step 3	In the Create MS-SPRing dialog box, enter the MS-SPRing information:

•Ring Type—Enter the ring type (2 Fiber) of the MS-SPRing.

•Ring Name—Enter the MS-SPRing name. If the node is being added to an MS-SPRing, use the MS-SPRing ring name.

•Node ID—Enter the node ID. If the node is being added to an MS-SPRing, use an ID that is not used by other MS-SPRing nodes in that ring.

•Ring Reversion—Enter the ring reversion time of the existing MS-SPRing.

•West Line—Enter the slot on the node that will connect to the existing MS-SPRing through the node’s west line (port).

•East Line—Enter the slot on the node that will connect to the existing MS-SPRing through the node’s east line (port).

Step 4 Click OK.

	Cisco ONS 15600 SDH Procedure Guide, R8.0
October 2007		18-49