Cisco Systems ONS 15600 SDH manual DLP-F319 Change an RS-DCC Termination, 18-19

Chapter 18 DLPs F300 to F399

DLP- F319 Change an RS-DCC Termination

DLP-F319 Change an RS-DCC Termination

	Purpose	This task modifies an RS-DCC termination. You can enable or disable Open
		Shortest Path First (OSPF) and enable or disable the foreign node setting.
	Tools/Equipment	None
	Prerequisite Procedures	DLP-F181 Log into CTC, page 16-34
	Required/As Needed	As needed
	Onsite/Remote	Onsite or remote
	Security Level	Provisioning or higher
Step 1	Click the Provisioning > Comm Channels > RS-DCC tabs.
Step 2	Click the RS-DCC that you want to change.
Step 3	Click Edit.
Step 4	In the RS-DCC Termination Editor dialog box, complete the following as necessary:

•Disable OSPF on RS-DCC Link—If checked, OSPF is disabled on the link. OSPF should be disabled only when the slot and port connect to third-party equipment that does not support OSPF.

•Far End is Foreign—Check this box to specify that the RS-DCC termination is a non-ONS node.

•Far End IP—If you checked the Far End is Foreign check box, type the IP address of the far-end node or leave the 0.0.0.0 default. An IP address of 0.0.0.0 means that any address can be used by the far end.

Step 5 Click OK.

Step 6 Return to your originating procedure (NTP).

DLP-F320 Change an MS-DCC Termination

Purpose	This task modifies an SDH MS-DCC termination. You can enable or
	disable OSPF and enable or disable the foreign node setting.
Tools/Equipment	None
Prerequisite Procedures	DLP-F181 Log into CTC, page 16-34
Required/As Needed	As needed
Onsite/Remote	Onsite or remote
Security Level	Provisioning or higher

Step 1 Click the Provisioning > Comm Channels > MS-DCC tabs.

Step 2 Click the MS-DCC that you want to change.

Step 3 Click Edit.

Step 4 In the MS-DCC Termination Editor dialog box, complete the following as necessary:

•Disable OSPF on MS-DCC Link—If checked, OSPF is disabled on the link. OSPF should be disabled only when the slot and port connect to third-party equipment that does not support OSPF.

	Cisco ONS 15600 SDH Procedure Guide, R8.0
October 2007		18-19