18-59
Cisco ONS 15600 SDH Procedure Guide, R8.0
October 2007
Chapter18 DLPs F300 to F399
DLP- F351 Roll the Source or Destination of One Optical Circuit
Step11 Click the Rolls tab (Figure 18-15). For the pending roll, view the Roll Valid Signal status. When one of
the following conditions are met, continue with Step12.
•If the Roll Valid Signal status is true, a valid signal was found on the new port.
•If the Roll Valid Signal status is false, a valid signal was not found. Wait until the signal is found
before continuing with the next step. If the signal is not found, refer to the “General
Troubleshooting” chapter in the Cisco ONS15600 SDH Troubleshooting Guide. To cancel the roll,
see the “DLP-F357 Cancel a Roll” task on page18-70.
•The roll is a one-way destination roll and the Roll Valid Signal is false. It is not possible to get a
Roll Valid Signal status of true for a one-way destination roll.
Note You cannot cancel an automatic roll after a valid signal is found.
•You can force a signal onto the Roll To circuit by using the ForceValid Signal button. If you choose
Force Valid Signal, traffic on the circuit that is involved in the roll might drop depending on
conditions at the other end of the circuit when the roll is completed. You must force a signal if the
circuits do not have a signal or have a bad signal and you want to complete the roll.
Note For a one-way destination roll in manual mode, you do not need to force the valid signal.
Figure18-15 Viewing the Rolls Tab
Step12 If you selected Manual in Step5, click the rolled facility on the Rolls tab and then click Complete. If
you selected Auto, continue with Step13 .
Step13 For both Manual and Auto rolls, click Finish to complete the circuit roll process. The roll clears from
the Rolls tab and the rolled circuit now appears on the Circuits tab in the DISCOVERED status.
Step14 Return to your originating procedure (NTP).