Cisco Systems ONS 15600 SDH manual DLP-F340 Change an MS-SPRing Node ID, 18-41

Chapter 18 DLPs F300 to F399

DLP- F340 Change an MS-SPRing Node ID

•East Line—Assign the east MS-SPRing port for the node from the drop-down list.

Step 5 Click OK.

Note Some or all of the following alarms will appear until all the MS-SPRing nodes are provisioned: E-W MISMATCH, RING MISMATCH, APSCIMP, APSDFLTK, and MSSP-OOSYNC. The alarms will clear after you configure all the nodes in the MS-SPRing.

Step 6 From the View menu, choose Go to Other Node.

Step 7 In the Select Node dialog box, choose the next node that you want to add to the MS-SPRing.

Step 8 Repeat Steps 1 through 7 at each node that you want to add to the MS-SPRing. When all nodes have been added, continue with Step 9.

Step 9 From the View menu, choose Go to Network View. After 10 to 15 seconds, verify the following:

•A green span line appears between all BLSR nodes.

•All E-W MISMATCH, RING MISMATCH, APSCIMP, APSDFLTK, and MSSP-OOSYNC alarms are cleared.

Step 10 Return to your originating procedure (NTP).

DLP-F340 Change an MS-SPRing Node ID

	Purpose	This task changes an MS-SPRing node ID.
	Tools/Equipment	None
	Prerequisite Procedures	DLP-F181 Log into CTC, page 16-34
	Required/As Needed	As needed
	Onsite/Remote	Onsite or remote
	Security Level	Provisioning or higher
Step 1	From the View menu, choose Go to Network View.
Step 2	On the network map, double-click the node with the node ID you want to change.
Step 3	From node view, click the Provisioning > MS-SPRingtabs.
Step 4	Choose a Node ID number. Do not choose a number already assigned to another node in the same
	MS-SPRing.
Step 5	Click Apply.
Step 6	Return to your originating procedure (NTP).

	Cisco ONS 15600 SDH Procedure Guide, R8.0
October 2007		18-41