Cisco Systems ONS 15600 SDH DLP-F394 Change Optics Threshold Settings for STM-N Ports, 18-113

Chapter 18 DLPs F300 to F399

DLP- F394 Change Optics Threshold Settings for STM-N Ports

Table 18-7	SDH Threshold Options (Line, Section, and Path) (continued)
Heading	Description	Options
PSD-W	Protection Switch Duration	Numeric. Can be set for 15-minute or one-day
	(Working Line)	intervals for Line (Near End). Select the bullet
		and click Refresh.
PSC-S	(Line) Sets the threshold for the span	Numeric. Can be set for 15-minute or one-day
	protection switching count. (PSC-S	intervals for Line (Near End). Select the bullet
	does not increment on STM-1 cards.)	and click Refresh.
PSD-S	(Line) Sets the threshold for the span	Numeric. Can be set for 15-minute or one-day
	protection switching duration.	intervals for Line (Near End). Select the bullet
	(PSD-S does not increment on	and click Refresh.
	STM-1 cards.)
PSC-R	(Line) Sets the threshold for the ring	Numeric. Can be set for 15-minute or one-day
	protection switching count. (PSC-R	intervals for Line (Near End). Select the bullet
	does not increment on STM-1 cards.)	and click Refresh.
PSD-R	(Line) Sets the threshold for the ring	Numeric. Can be set for 15-minute or one-day
	protection switching duration.	intervals for Line (Near End). Select the bullet
	(PSD-R does not increment on	and click Refresh.
	STM-1 cards.)

Step 3 Click Apply.

Step 4 Return to your originating procedure (NTP).

DLP-F394 Change Optics Threshold Settings for STM-N Ports

Purpose	This task changes optics threshold settings for STM-N ports.
Tools/Equipment	None
Prerequisite Procedures	DLP-F181 Log into CTC, page 16-34
Required/As Needed	As needed
Onsite/Remote	Onsite or remote
Security Level	Provisioning or higher

Note For the default values and domains of user-provisionable card settings, refer to the "Network Element Defaults" appendix in the Cisco ONS 15600 SDH Reference Manual.

Step 1 On the shelf graphic, double-click the STM-16, STM-64, or ASAP card that you want to provision. The card view appears.

Step 2 As needed, complete the following:

a.Click Optics Thresholds to provision the options in Table 18-8for each STM-N port.

b.Select the TCA (threshold crossing alert) or Alarm radio button.

	Cisco ONS 15600 SDH Procedure Guide, R8.0
October 2007		18-113