Chapter 18 DLPs F300 to F399
DLP- F315 Provision a Proxy Tunnel
–ISH—Sets the Intermediate System Hello PDU propagation frequency. Intermediate system NEs send ISHs to other ESs and ISs to inform them about the IS NETs it serves. The default is 10 seconds. The range is 10 to 1000 seconds.
–IIH—Sets the Intermediate System to Intermediate System Hello PDU propagation frequency. The IS-IS Hello PDUs establish and maintain adjacencies between ISs. The default is 3 seconds. The range is 1 to 600 seconds.
–IS-IS Cost—Sets the cost for sending packets on the LAN subnet. The IS-IS protocol uses the cost to calculate the shortest routing path. The default metric cost for LAN subnets is 20. It normally should not be changed.
Step 9 Click Finish.
Note MS-DCC Termination Failure (EOC-L) and Loss of Signal (LOS) alarms appear until you create all network DCC terminations and put the DCC termination STM-N ports in service.
Step 10 Return to your originating procedure (NTP).
DLP-F315 Provision a Proxy Tunnel
Purpose | This task sets up a proxy tunnel to communicate with a non-ONS far-end |
| node. Proxy tunnels are only necessary when the proxy server is enabled |
| and a foreign DCC termination exists, or if static routes exist so that the |
| DCC network is used to access remote networks or devices. You can |
| provision a maximum of 12 proxy server tunnels. |
Tools/Equipment | None |
Prerequisite Procedures | DLP-F181 Log into CTC, page 16-34 |
| DLP-F253 Provision RS-DCC Terminations, page 17-45 |
Required/As Needed | As needed |
Onsite/Remote | Onsite or remote |
Security Level | Superuser only |
Note If the proxy server is disabled, you cannot set up a proxy tunnel.
Step 1 Click the Provisioning > Network > Proxy subtabs.
Step 2 Click Create.
Step 3 In the Create Tunnel dialog box, complete the following:
•Source Address—Type the IP address of the source node (32 bit length) or source subnet (any other length).
•Length—Choose the length of the source subnet mask.
•Destination Address—Type the IP address of the destination node (32 bit length) or destination subnet (any other length).
•Length—Choose the length of the destination subnet mask.
| Cisco ONS 15600 SDH Procedure Guide, R8.0 |
18-16 | October 2007 |
