18-84
Cisco ONS 15600 SDH Procedure Guide, R8.0
October 2007
Chapter18 DLPs F300 to F399
DLP- F373 Edit the OSI Subnetwork Point of Attachment
DLP-F373 Edit the OSI Subnetwork Point of Attachment
Step1 In the node view, click the Provisioning > OSI > Routers > Subnet tabs.
Step2 Choose the subnet you want to edit, then click Edit.
Step3 In the Edit subnet type Subnet slot/port dialog box, edit the following fields:
•ESH—The End System Hello PDU propagation frequency. The field is not used by the
ONS 15600 SDH.
•ISH—The Intermediate System Hello PDU propagation frequency. An intermediate system NE
sends ISHs to other ESs and ISs to inform them about the NETs it serves. The default is 10 seconds.
The range is 10 to 1000 seconds.
•IIH—The Intermediate System to Intermediate System Hello PDU propagation frequency. The IS-IS
Hello PDUs establish and maintain adjacencies between ISs. The default is 3 seconds. The range is
1 to 600 seconds.
Note The IS-IS Cost and DIS Priority parameters are provisioned when you create or enable a subnet.
You cannot change the parameters after the subnet is created. To change the DIS Priority and
IS-IS Cost parameters, delete the subnet and create a new one.
Click OK.
Step4 Return to your originating procedure (NTP).
DLP-F374 Edit an IP-Over-CLNS Tunnel
Purpose This task allows you to view and edit the OSI subnetwork point of
attachment parameters. The parameters are initially provisioned when you
create a regenerator section DCC (RS-DCC) or multiplex section DCC
(MS-DCC), or when you enable the LAN subnet.
Tools/Equipment None
Prerequisite procedures DLP-F181 Log into CTC, page 16-34
Required/As needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This task allows you to edit the parameters of an IP-over-CLNS tunnel.
Tools/Equipment None
Prerequisite procedures DLP-F369 Create an IP-Over-CLNS Tunnel, page 18-80
DLP-F181 Log into CTC, page 16-34
Required/As needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher