Cisco Systems ONS 15600 SDH manual Sonet, 18-109

Chapter 18 DLPs F300 to F399

DLP- F392 Change Line Transmission Settings for STM-N Cards

Table 18-6	STM-N Card Line Settings (continued)
Heading		Description	Options
Admin State		Sets the port service state unless	•	Unlocked—Puts the port in service. The
		network conditions prevent the		port service state changes to
		change.		Unlocked-enabled.
			•	Unlocked,automaticInService—Puts the
				port in automatic in-service. The port
				service state changes to
				Unlocked-disabled,automaticInService.
			•	Locked,disabled—Removes the port
				from service and disables it. The port
				service state changes to
				Locked-enabled,disabled.
			•	Locked,maintenance—Removes the port
				from service for maintenance. The port
				service state changes to
				Locked-enabled,maintenance.
			Note CTC will not allow you to change a
				port service state from
				Unlocked-enabled to
				Locked-enabled,disabled. You must
				first change a port to the
				Locked-enabled,maintenance service
				state before putting it in the
				Locked-enabled,disabled service
				state.
AINS Soak		Sets the automatic in-service soak	Duration of valid input signal, in hh.mm
		period.	format, after which the card becomes
			Unlocked-enabled automatically (0 to 48
			hours, in 15-minute increments).
SyncMsgIn		Enables synchronization status	•	Yes (checked; default)
		messages (S1 byte), which allow the	•	No (unchecked)
		node to choose the best timing source.
Port Rate		(ASAP card only.) Displays the port	•	STM-1
		rate set for the PPM.	•	STM-4
			•	STM-16
			•	STM-64
			•	Ether
Type		Defines the port as SDH or SONET.	•	SDH (default)
		Sync Msg In and Send Do Not Use	•	SONET
		must be disabled before the port can
		be set to SONET.

	Cisco ONS 15600 SDH Procedure Guide, R8.0
October 2007		18-109