Chapter 18 DLPs F300 to F399
DLP- F333 Install the ASAP Carrier Modules
Step 10 Return to your originating procedure (NTP).
DLP-F333 Install the ASAP Carrier Modules
Purpose | This procedure explains how to install the carrier modules in the |
| ONS 15600 SDH shelf. |
Tools/Equipment | ASAP carrier modules |
Prerequisite Procedures |
|
Required/As Needed | As needed |
Onsite/Remote | Onsite |
Security Level | None |
Warning During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly touch the midplane with your hand or any metal tool, or you could shock yourself. Statement 181
Caution Always use the supplied ESD wristband when working with a powered ONS 15600 SDH. Plug the wristband cable into the ESD jack located on the
Warning Class 1 laser product. Statement 1008
Warning Invisible laser radiation may be emitted from the end of the unterminated fiber cable or connector. Do not view directly with optical instruments. Viewing the laser output with certain optical instruments (for example, eye loupes, magnifiers, and microscopes) within a distance of 100 mm may pose an eye hazard. Statement 1056
Warning Use of controls, adjustments, or performing procedures other than those specified may result in hazardous radiation exposure. Statement 1057
Note For information about the ASAP card, refer to the Cisco ONS 15600 SDH Reference Manual.
Step 1 Remove the carrier module from the box and antistatic sleeve.
Caution Setting an ASAP carrier module on its connectors can cause damage to the connectors.
Step 2 Slide the module along the top and bottom guide rails into the correct slot: Slots 1 to 4 and 11 to 14 are available for traffic cards. Insert the card until it contacts the backplane.
Step 3 Close the ejectors.
|
| Cisco ONS 15600 SDH Procedure Guide, R8.0 |
|
| |
|
|
| |||
| October 2007 |
|
|
|
|
|
|
|
| ||
