18-77
Cisco ONS 15600 SDH Procedure Guide, R8.0
October 2007
Chapter18 DLPs F300 to F399
DLP- F364 Remove a Static TID-to-NSAP Entry from the TARP Data Cache
DLP-F364 Remove a Static TID-to-NSAP Entry from the TARP Data Cache
Step1 In node view, click the Provisioning > OSI > TARP > Static TDC tabs.
Step2 Click the static entry that you want to delete.
Step3 Click Delete Static Entry.
Step4 In the Delete TDC Entry dialog box, click Yes .
Step5 Return to your originating procedure (NTP).
DLP-F365 Add a TARP Manual Adjacency Table Entry
Step1 In the node view, click the Provisioning > OSI > TARP > MAT tabs.
Step2 Click Add.
Step3 In the Add TARP Manual Adjacency Table Entry dialog box, enter the following:
•Level—Sets the TARP Type Code that will be sent:
–
Level 1—Indicates that the adjacency is within the same area as the current node. The entry
generates Type1 PDUs.
–
Level 2—Indicates that the adjacency is in a different area than the current node. The entry
generates Type 2 PDUs.
•NSAP—Enter the OSI NSAP address in the NSAP field or, if preferred, click Use Mask and enter
the address in the Masked NSAP Entry dialog box.
Step4 Click OK to close the Masked NSAP Entry dialog box, if used, and then click OK to close the Add Static
Entry dialog box.
Purpose This task removes a static TID-to-NSAP entry from the TDC.
Tools/Equipment None
Prerequisite procedures DLP-F181 Log into CTC, page 16-34
Required/As needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioner or higher
Purpose This task adds an entry to the TARP manual adjacency table (MAT). Entries
are added to the MAT when the ONS15600 SDH must communicate across
routers or non-SDH NEs that lack TARP capability.
Tools/Equipment None
Prerequisite procedures DLP-F181 Log into CTC, page 16-34
Required/As needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher