Cisco Systems ONS 15600 SDH manual DLP-F350 Delete an MS-SPRing from a Single Node, 18-56

Chapter 18 DLPs F300 to F399

DLP- F350 Delete an MS-SPRing from a Single Node

Step 4 Return to your originating procedure (NTP).

DLP-F350 Delete an MS-SPRing from a Single Node

Purpose	This task deletes an MS-SPRing from a node after you remove the node
	from the MS-SPRing.
Tools/Equipment	None
Prerequisite Procedures	DLP-F181 Log into CTC, page 16-34
Required/As Needed	As needed
Onsite/Remote	Onsite or remote
Security Level	Provisioning or higher

Step 1 In node view, display the node that was removed from the MS-SPRing:

•If the node that was removed is connected to the same LAN as your computer, from the File menu, choose Add Node, then enter the node name or IP address.

•If the node that was removed is not connected to the same LAN as your computer, you must connect to the node using a direct connection. See Chapter 3, “Connect the PC and Log into the GUI” for procedures.

Step 2 Click the Provisioning > MS-SPRing tabs.

Step 3 Highlight the ring and click Delete.

Step 4 In the Suggestion dialog box, click OK.

Step 5 In the confirmation message, confirm that this is the ring you want to delete. If so, click Yes. Step 6 Return to your originating procedure (NTP).

DLP-F351 Roll the Source or Destination of One Optical Circuit

Purpose	This task reroutes traffic from one source or destination to another on the
	same circuit, thus changing the original source or destination.
Tools/Equipment	None
Prerequisite Procedures	DLP-F181 Log into CTC, page 16-34
Required/As Needed	As needed
Onsite/Remote	Onsite or remote
Security Level	Provisioning or higher

Step 1 From the View menu, choose Go To Network View.

Step 2 Click the Circuits tab.

Step 3 Click the circuit that you want to roll. The circuit must have a DISCOVERED status for you to start a roll.

	Cisco ONS 15600 SDH Procedure Guide, R8.0
18-56	October 2007