Cisco Systems ONS 15600 SDH manual DLP-F359 Change the Optical Line Rate, 18-71

Chapter 18 DLPs F300 to F399

DLP- F359 Change the Optical Line Rate

Note The ASAP card hosts up to four 4PIO modules. Each 4PIO hosts four SFPs, which provide a fiber interface that must be provisioned as STM-1, STM-4, STM-16, or Gigabit Ethernet. SFPs are called pluggable port modules (PPMs) in CTC.

Step 1 In node view, double-click the ASAP card where you want to provision PPM settings. Step 2 Click the Provisioning > Pluggable Port Modules tabs.

Step 3 In the Pluggable Port Modules area, click Create. The Create PPM dialog box appears. Step 4 In the Create PPM dialog box, complete the following:

•PPM—Click the slot number where the SFP is installed from the drop-down list.

•PPM Type—Click the number of ports supported by your SFP from the drop-down list. If only one port is supported, PPM (1 port) is the only option.

Step 5 Click OK. The newly created port appears in the Pluggable Port Modules area. The row on the Pluggable Port Modules area turns light blue if the PPM is provisioned strictly as an optical PPM, or green if it is provisioned as a DWDM PPM. The Actual Equipment Type column lists the equipment name.

Step 6 Verify that the PPM appears in the list in the Pluggable Port Modules area. If it does not, repeat Steps 3 through 5.

Step 7 Repeat the task to provision a second PPM.

Step 8 Click OK.

Step 9 Continue with the “DLP-F390 Provision an Optical Line Rate and Wavelength” task on page 18-103to provision the line rate.

Step 10 Return to your originating procedure (NTP).

DLP-F359 Change the Optical Line Rate

	Purpose	This task changes PPM port rates for the ASAP card. Perform this task if
		you want to change the port rate on a multirate SFP that is already
		provisioned.
	Tools/Equipment	None
	Prerequisite Procedures	DLP-F181 Log into CTC, page 16-34
	Required/As Needed	As needed
	Onsite/Remote	Onsite or remote
	Security Level	Provisioning or higher
Step 1	In node view, double-click the ASAP card where you want to edit the PPM port rate.
Step 2	Click the Provisioning > Pluggable Port Modules tabs.
Step 3	Click the port with the port rate that you want to change in the Pluggable Ports area. The highlight
	changes to dark blue.
Step 4	Click Edit. The Edit Port Rate dialog box appears.
Step 5	In the Change To field, use the drop-down list to select the new port rate and click OK.
		Cisco ONS 15600 SDH Procedure Guide, R8.0
October 2007			18-71