Cisco Systems ONS 15600 SDH manual DLP-F311 Remove Pass-through Connections, 18-12

Chapter 18 DLPs F300 to F399

DLP- F311 Remove Pass-through Connections

Step 4	Choose the JRE version.
Step 5	Click OK.
Step 6	From the File menu, choose Exit.
Step 7	In the confirmation dialog box, click Yes.
Step 8	Return to your originating procedure (NTP).

DLP-F311 Remove Pass-through Connections

	Purpose		This task removes pass-through connections from a node deleted from a
			ring.
	Tools/Equipment		None
	Prerequisite Procedures		DLP-F181 Log into CTC, page 16-34
	Required/As Needed		As needed
	Onsite/Remote		Onsite or remote
	Security Level		Provisioning or higher
Step 1	Log into the deleted node.
Step 2	In the CTC Login dialog box, check the Disable Network Discovery check box.
Step 3	Choose None from the Additional Nodes drop-down list.
Step 4	Click the Login button.
Step 5	Click the Circuits tab. All internode circuits are shown as PARTIAL.
Step 6	Refer to the diagram or CTC printout you created in the “NTP-F215 Remove an MS-SPRing Node”
	procedure on page 13-5or the “NTP-F217 Remove an SNCP Node” procedure on page 13-10. Find the
	circuits on the line cards of the removed node.
Step 7	Click the Filter button.
Step 8	Type the slot and port of a trunk card on the removed node.
Step 9	Click OK.
Step 10	In the Circuits tab, select all PARTIAL circuits that pass the filter and click the Delete button.
	Note To select more than one circuit, press the Shift key and simultaneously click on all circuits to be
		deleted.
Step 11	Repeat Steps 6 through 10 for the other trunk card.
Step 12	Log out of CTC.
Step 13	Return to your originating procedure (NTP).

	Cisco ONS 15600 SDH Procedure Guide, R8.0
18-12	October 2007